Eglu HUB
- The communication gateway which can be
directly plugged into a wall socket. - It connects to the internet via home’s Wi-Fi
router. - The whole setup takes less than 2 minutes and
can be done through the eGlu APP.
Sensor Monitor can convert a wired sensor like smoke detector, gas leak detector etc.
into a wireless sensor. The wired sensor must have ‘NO/NC’ trigger output which should
be connected to the Sensor Monitor. SMHV also provides a 12V/100mA DC output which
can be used to power the wired sensor.
Curtain Controller lets you control your motorized window curtains as well as motorized
main gates. It supports all the motors which use AC phase switching for open and close
operations. Curtain Controller can support up to 6A of AC motor load. It also has an
option to connect physical bell switches for local control.
Panic Alarm produces loud sound when turned on. It can be activated based on various
events like intrusion, opening of a door or pressing of the panic button on the TAG. Panic
Alarm is powered by batteries and can be conveniently placed on any flat surface or
hang on a wall.
RGB LED Controller can control the colours and brightness of the connected RGB LED
strip. RLC requires an external 12V DC power supply and the RGB LED strip.
Gate Controller lets you control your motorized gate. The controller is connected in parallel to the manual gate open/close switch point. The Gate Controller has 3 relay outputs which provides a momentary pulse.
Door Sensor helps in monitoring the opening and closing of the doors and windows. It
also provides the real time state of the door/window on which it is installed. Apart from
sensing door, it can also be used as a presence sensor or a remote button.
Smart Plug 6A converts existing wall socket into a remote controlled switch. Any appliance which
takes a maximum load current of 6A can be used with this plug.
Examples: Lamps,Table Fans, Coffee Maker, Decorative Lights. The plug also has a push button
which can be used for local on/off control.
Sensor Monitor is designed to convert an existing low power sensor like Motion Glass
Break Sensor etc. into a wireless sensor. The only requirement is that the wired sensor
should have an ‘NO/NC’ trigger. SMLV can be powered from the same DC source which
is powering the sensor, mostly a battery. SMLV can monitor three ‘NO/NC’ Inputs. ‘NO’
connection is recommended as it increases the battery life.