-
eGlu Curtain Controller (CC)
Curtain Controller lets you control your motorized window curtains as well as motorized
main gates. It supports all the motors which use AC phase switching for open and close
operations. Curtain Controller can support up to 6A of AC motor load. It also has an
option to connect physical bell switches for local control. -
eGlu Dual Relay Controller (RC2)
Dual Relay Controller is a general purpose automation device. It contains two relays with
voltage rating of 220V and current rating of 6A. The relays can take both AC and DC
inputs for the given ratings. Dual Relay Controller also has the option to connect physical
AC switches for the local control of the relays. -
eGlu Gate Controller (GC)
Gate Controller lets you control your motorized gate. The controller is connected in parallel to the manual gate open/close switch point. The Gate Controller has 3 relay outputs which provides a momentary pulse.
-
eGlu In-wall 16A Switch (IWS-16A)
In-wall 16A Switch Module can be used to remotely control or automate high power
appliances like geysers, air conditioners and motor pumps with maximum load up to
16A. It is installed behind the existing switch plate and works in parallel with the mechanical
switch. -
eGlu Motor Controller
- Motor Controller lets you control your motorized
- Window curtains as well as motorized main gates
- It supports all the motors which use AC phase
- Switching foe open and close operations
- Motor controller can support up to 6A of AC motor
load - It also has option to connect physical bell switches
for local control
-
eGlu RGB LED Controller (RLC)
RGB LED Controller can control the colours and brightness of the connected RGB LED
strip. RLC requires an external 12V DC power supply and the RGB LED strip. -
eGlu Sensor Monitor HV (SMHV)
Sensor Monitor can convert a wired sensor like smoke detector, gas leak detector etc.
into a wireless sensor. The wired sensor must have ‘NO/NC’ trigger output which should
be connected to the Sensor Monitor. SMHV also provides a 12V/100mA DC output which
can be used to power the wired sensor. -
eGlu Sensor Monitor LV (SMLV)
Sensor Monitor is designed to convert an existing low power sensor like Motion Glass
Break Sensor etc. into a wireless sensor. The only requirement is that the wired sensor
should have an ‘NO/NC’ trigger. SMLV can be powered from the same DC source which
is powering the sensor, mostly a battery. SMLV can monitor three ‘NO/NC’ Inputs. ‘NO’
connection is recommended as it increases the battery life. -
eGlu Triple Relay Controller (RC3)
Triple Relay Controller is a general purpose automation device. It contains three relays
with voltage rating of 220V and current rating of 3A each. The relays can take both AC
and DC inputs for the given ratings. -
eGlu Yale Lock Controller (YLC)
Yale Lock Controller is designed to remotely operate your Yale locks which are compatible with the K-type or N-type Yale receiver/transceiver modules. The Yale receiver
module is installed in the lock and the Yale transmitter module is interfaced with the
YLC, which also provides power to the transmitter module.